![](/jointfilesconvert/364418/bg1d.png)
Manual No. 016-0171-093 23
CHAPTER
6
CH A PTE R 6
SmartRow Operation
Initial Startup
Before beginning your first application, you need to install and configure SmartRow for your planter.
Refer to the following points to set up SmartRow. This ensures that SmartRow is configured for the
specific equipment with which it will be operating.
1. Set up the GPS System - Refer to your GPS receiver operator’s manual to set up your GPS
receiver to output a GPS signal to SmartRow. SmartRow requires both GGA position and VTG
speed messages from the receiver. Message output rates should be at least 4 Hz. An output rate of
10 Hz is recommended.
2. Select the Planter mode (either electric or pneumatic (air) clutch) from the System Config menu.
3. Select Distance Units - Use the SmartRow Section Configuration Menus to set up the units that
SmartRow will use to measure. You can select inches or centimeters.
4. Configure The Sections Widths - Use the SmartRow Sections Configuration Menus to set up the
number of section and the width of each section.
5. Orient the implement with respect to the GPS antenna - Use the SmartRow Sections Configuration
Menus to enter the location of the center of the implement with respect to the GPS Antenna.
Comentários a estes Manuais