Raven Cruizer II Manual do Utilizador descarregar pdf (Página 6)

4 Cruizer II™ Operation Guide

Installation

1. Mount the antenna on the centerline of the tallest point of the vehicle

(usually on the top of the vehicle cabin) using the magnetic mount. Make

sure that the antenna has a clear, 360° view of the sky. If the mounting

location is not metallic, use a mounting plate (supplied with helix style

antenna) to mount the antenna.

2. Route the antenna cable to the back of the Cruizer II console and connect

it to the antenna port.

3. Connect the power cable to the power port on the Cruizer II and plug the

adaptor into the vehicle accessory port or cigarette lighter socket.

4. Using the RAM mount arm, mount the Cruizer II inside the cab to a clean

surface.

For additional cabling and connection assistance, see the System

Connection Diagrams section on page 36. Additional system diagrams

are available on the Raven web site.

Note: Throughout this manual, text may appear either in blue or bolded. The

blue text are references to section headings or the Raven web site.

Refer to these sources for more information. The bolded text are

names of Cruizer II icons.

Arrows ( ) within the following sections indicate a series of icons

that must be selected to complete the procedure.

Boom Sense Interface Installation

A boom sense adapter (P/N 115-0171-792 or 115-0171-794) will be required

to toggle coverage history, or “painting,” on or off based upon a machine or

implement switch during a field operation. Once installed, Review the Switch

settings in the System section on page 19 and select the Hardware option to

enable the Cruizer II to reference the switch status for coverage history. To

install the boom sense adapter (P/N 115-0171-792):

1. Connect the 9-pin serial connection to port B on the back of the Cruizer II.

2. Route a source of 12 volt power to the spade connection on the adapter

controlled by a switch to toggle the signal.

When 12 volts is detected on this line, Cruizer will toggle the coverage

history on and map to “paint” active coverage.

To install the steering interface with sense adapter (P/N 115-0171-794):

1. Connect the 9-pin serial connection to port B on the back of the Cruizer II.

2. Route the switch signal to the grey spade terminal on the interface cable.

If tapping into an existing switch, only the signal connection is required.

When 12 volts is detected on this line, Cruizer will toggle the coverage

history on the map to “paint” active coverage.

3. If installing a separate switch specifically for the Cruizer coverage history,

route connect the red lead to the switch.

Cruizer will supply voltage to the switch. When the switch is closed, signal

will return to the Cruizer to toggle coverage history on the map to “paint”

active coverage.

Warning: Do not cut off accessory plug or modify the power cable

in any way. The accessory plug offers fuse protection.

Modification of any of the supplied parts could result in

injury or death.

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Comentários a estes Manuais

Sem comentários

Raven Cruizer II Manual do Utilizador Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de navegação Raven Cruizer II