Raven Cruizer II Manual do Utilizador descarregar pdf (Página 7)

Manual No. 016-0171-415 Rev. F 5

Initial Startup

The first time that the console is powered up, a Setup Wizard will step through

the initial setup and calibration. The Setup Wizard helps with the configuration

process and is only required the first time the Cruizer II is started. Any settings

selected or calibration values entered in the Setup Wizard may be adjusted at

any time via the Tools Menu. See the Tools Menu section on page 19 for

more information.

Note: If the touch screen does not properly power up, refer to the

Troubleshooting section on page 34.

1. Press the power button on the side of the console.

2. On the first screen, select the language and either Metric (meters, km/h,

hectares etc.) or U.S. (inches, mph, acres etc.) for the units display.

3. Touch Next to accept the selected settings and to advance to Width

Setup screen.

4. Use the displayed keypad to enter the overall implement, equipment or

boom width in the units selected on the previous screen.

5. Touch Next to accept the displayed selection and to advance to the

Antenna Position screen.

Use the Antenna Position screen to set the position of the GPS antenna

with respect to the center of the boom or implement width.

The left side of the Antenna Position screen displays a visual reference of

the location of the boom or implement and DGPS antenna. After the

antenna offsets are programmed, the antenna position display should

show a general representation of the actual machine configuration.

To set the Antenna Position offsets, touch the desired offset value and use

the on-screen keypad to enter the new value.

The following offset values may be modified on the Antenna Position

screen:

• Fore/Aft - The fore/aft offset is the distance of the boom or implement in

front or behind the GPS antenna.

Note: The fore/aft offset must be measured perpendicular to the boom or

implement width.

Current

Offset Units

Current

Offset Values

Boom/Implement

Location Selection

Live Antenna

Position Display

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Sem comentários

Raven Cruizer II Manual do Utilizador Página 7